Netscout OptiView XG, Getting Started Manual

Page: 24 / 77

18
Operating your OptiView XG
Power Modes
Powering On
1. Connect the AC adapter to a power source and to the OptiView XG Network Analysis Tablet. See Figure 12,
“Powering On” for the location of the power connector and power button.The batteries are not fully
charged before shipment due to transportation regulations.
2. Charge the batteries to full capacity before disconnecting the AC adapter. Charge time is approximately
3 hours. Run time is approximately 2 hours with fully charged batteries.


If running wireless only, the run time is approximately 4 hours.
• If the OptiView XG is powered-on, see the Battery Status Window (see
page 38
) to verify that
batteries are fully charged.
• If the OptiView XG is powered-off use the Battery Charge Status LED (see
page 37
) or the Battery
Charge Indicators on the batteries (see
page 38
) to verify that batteries are fully charged.
3. Press the green On/Off button to power-on the OptiView XG.
Figure 12. Powering On
The OptiView XG will power-up. The following screens will be displayed during power up:
1. Blank screen.
2. NETSCOUT splash screen.
3. Operating system startup screens.
4. NETSCOUT desktop background.
5. The OptiView XG application.
Power button
Power connector