5
NETO
SET UP
1 Power
The Renegade XB is equipped with an auto-ranging power factor correct-
ed switch-mode power supply. 100-240 VAC 50/60Hz capable.
Maximum current draw of 3.5A (120V) / 1.9A (230V). Never connect pow-
er to a dimmer pack even if it is locked to 100%. If unit does not power
on disconnect power and check fuse. Fuse rating must be
XXX
. If multiple
fixtures are on one circuit avoid striking the lamps all at the same time
as the unit pulls excessive current for a short duration during ignition. If
unit does not power on, disconnect power and contact NETO Lighting for
service.
2 Data
Data is daisy chained via the XLR 3pin connectors. DMX512 low imped-
ance data cabling is recommended for optimal signal transmission.
3 Rigging
The fixture comes with a quarter-turn omega bracket for mounting
clamps to base. Never mount a fixture in a position that could easily be
knocked over and cause harm to anyone or the fixture itself. Only expe-
rienced persons should be rigging fixtures overhead. Always use a safety
cable to ensure security. Always verify that the safe working load of the
structure is greater than the total load of fixtures on said structure.