LED
Mark
Status
Description
Power
PWR
On
Device is powered up.
Off
Device is powered down.
Optical
signal
loss
LOS
Blink
Device does not receive optical signals.
Off
Device has received
optical signal.
Registration
REG/PON
On
Device is registered
to the
PON system.
Off
Device is not
registered to the
PON system.
Blink
Device
is registering.
Interface
GE
、
FE/
LAN1~2
On
Port is connected
properly.
Off
Port
connection exception
or not connected.
Blink
Port is
sending or/and receiving data.
POTS
FXS/PHONE
On
Device has registered to the soft-switch, but
without ongoing data transmission.
Off
Device is power off or not registered to the
soft-switch.
Blink
The port is with ongoing data transmission.
Wireless(for
HG323RW/RWT)
WiFi
On
WiFi turned on.
Off
Device is power off or WiFi turned off.
Blink
WiFi data transmission.
CATV(for
HG323RWT
)
CATV
On
1550nm wavelength power of input is in normal
Off
1550nm wavelength power of input is too low or
no input.
Blink
1550nm wavelength power of input is too high.
Pair
(for
HG323RW
)
Pair
On
WPS client is connected. ( LED turn off after 5
minutes of successful connection)
Off
Does not use WPS or WPS client is
connected.( LED turn off after 5 minutes of
successful connection)
Blink
WPS client is connecting.
Table 3 Panel lights
on
1.6
Interface description
Port Type
Function
PON
HG323RW: SC/UPC type, single mode optical fiber cable
HG323RWT: SC/APC type, single mode optical fiber cable with WDM
GE
、
FE
Connect device with ethernet port by RJ-45 cat5 cable.
FXS
Connect the telephone with FXS port by telephone wire.
RST
Press down reset button and keep1-5seconds to make the device
restart and recover from the factory default settings.
DC12V
Connect with power adapter.
Pair
☆
Press down WiFi pair button to begin pairing.
G/EPON 1GE+1FE+1POTS+WiFi+CATV ONU Introduction V1.0
4
www.netlinkict.com
