150Mbps Wireless-NHigh Gain Broadband Router
User Manual
WAN light should be blinking. If you use your computer, the corresponding LAN port
light should be blinking too. If not, please check whether the cables work or not.
Repeat the steps in
WAN Setup
Connect with Internet through DSL Modem.
4. I can browse the router’s Web-based Configuration Utility but cannot access the
Internet.
Check if the WAN LED is ON. If not, verify that the physical connection between the
router and the DSL/Cable modem is firmly connected. Also ensure the DSL/Cable
modem is working properly.
If WAN LED is ON, open the System Overview page of the Web configuration utility
and check the status group to see if the router’ s WAN port has successfully obtained an
IP address.
Make sure you are using the correction method (Dynamic IP Address, PPPoE, or Static
IP) as required by the ISP. Also ensure you have entered the correct settings provided by
the ISP.
For cable users, if your ISP requires a registered Ethernet card MAC address, make sure
you have cloned the network adapter’ s MAC address to the WAN port of the router.
(See the
MAC Address
field in
WAN Setup
.)
5. My wireless client cannot communicate with another Ethernet computer.
Ensure the wireless adapter functions properly. You may open the Device Manager in
Windows to see if the adapter is properly installed.
Make sure the wireless client uses the same SSID and security settings (if enabled) as the
150Mbps Wireless-N High Gain Broadband Router.
Ensure that the wireless adapter’s TCP/IP settings are correct as required by your
network administrator.
If you are using a 802.11b wireless adapter, and check that the
802.11G
Mode item in
Wireless Basic Setting
page, is not configured to use 802.11G Performance.
Use the ping command to verify that the wireless client is able to communicate with the
router’s LAN port and with the remote computer. If the wireless client can successfully
ping the router’ s LAN port but fails to ping the remote computer, then verify the TCP/IP
settings of the remote computer.
6.I don’t know how to use the router in different modes.
You
Acce
AP
: The default setting is AP mode
，
at this point the router can be used as wired and
wireless signal converter
，
In this mode, you can use wireless access instead of cable access.
can select radio mode of wireless routerin “wireless”—“wireless settings”, it contains
ss Point, WDS,AP+WDS,Client, and Repeater.
Most connections utilize a dynamic ip (DHCP) and the default is already set to this .If you
60
