you can continue to use to log in over a WiFi connection to the local browser UI
of the access point.
In addition to the management SSID, the access point supports four WiFi networks.
By default, only the main WiFi network is enabled.
c. In the Passphrase field, specify a passphrase (WiFi password) for the main WiFi
network.
This passphrase must be a minimum of 8 characters and can be a maximum of
63 characters.
This passphrase does
not
replace the passphrase for the management SSID,
which you can continue to use to log in over a WiFi connection to the local browser
UI of the access point.
d. Select the check box to accept NETGEAR’s terms and conditions and acknowledge
that you read the privacy notice.
e. Click the Apply button.
Yous settings are saved. The access point restarts. After about two minutes, the
login page displays.
6. If the login page does not display, in the address field of your web browser, enter
the IP address that is assigned to the access point.
Note: If your browser displays a security message and does not let you proceed,
see Step 4.
7. In the Local Device Password field, enter your new local device password, and click
the Login button.
The Device Status page displays. You can now configure the access point for your
network and environment.
When to use aplogin.net and when to use
the assigned IP address
Use https://www.aplogin.net (which is the same as https://192.168.0.100)
only
when you connect to the access point over the 2.4 GHz management SSID, that is, over
the ”CONFIG-ONLY“ SSID. For more information, see 2.4 GHz management SSID on
page 58.
For all other types of connections, use the IP address that was assigned to the access
point by your existing router or DHCP server during the setup process (see Initial log-in
process on page 26) to log in to the local browser UI of the access point.
User Manual
32
Installation and Initial Log-in
NETGEAR WiFi 6 AX1800/AX3600 Dual Band PoE/PoE+ Access Points, WAX214 and WAX218
