Model SB104 10 Mbps Network Starter Kit Installation Guide
Federal Communications Commission (FCC) Compliance Notice: Radio Frequency
Notice (for the Model FA310TX Network Card)
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, (2) This device must accept any interference
received, including interference that may cause undesired operation.
Note: The Model FA310TX Network Card has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
EN 55 022 Statement (for the Model EN104
TP
Ethernet Hub)
This is to certify that the Model EN104
TP
Ethernet Hub is shielded against the generation of radio interference
in accordance with the application of Council Directive 89/336/EEC, Article 4a. Conformity is declared by the
application of EN 55 022 Class A (CISPR 22).
EN 55 022 Statement (for the Model FA310TX Network Card)
This is to certify that the Model FA310TX Network Card is shielded against the generation of radio
interference in accordance with the application of Council Directive 89/336/EEC, Article 4a. Conformity is
declared by the application of EN 55 022 Class B (CISPR 22).
Compliance is dependent upon the use of shielded data cables.
Note: Modifications to this device change it from the original state it was in when tested and
may alter the device so that it no longer complies with FCC testing limitations for Class B digital
devices. According to FCC regulations, the user could be prevented from operating this
equipment if it is modified.
Warning: This is a Class A product. In a domestic environment, this product may cause radio
interference, in which case, the user may be required to take appropriate measures.
Declaration of Conformity
NETGEAR Model FA310TX Network Card
FOR HOME OR OFFICE USE
Tested to comply
with FCC Standards
Summary of Contents for Sb 104
Page 1: ......