Chapter 4. Advanced Configuration
|
31
ProSafe Wireless-N Access Point WNAP320 Reference Manual
Configuring a Point-to-Multi-Point Wireless Bridge
Figure 8. To configure a point-to-multi-point wireless bridge as shown in
1.
Select
Configuration > Wireless Bridge > Bridging and Repeating
. The Bridging and
Repeating screen displays.
Figure 9.
2.
Configure the operating mode of the access points:
•
Configure WNAP320 (AP1) on LAN Segment 1 in point-to-point bridge mode with the
remote MAC address of AP2.
•
Because it is in the central location, configure WNAP320 (AP2) on LAN Segment 2 in
Point-to-Multi-Point Bridge mode. The MAC addresses of the adjacent APs are
required in AP2.
•
Configure the WNAP320 (AP3) on LAN 3 in Point-to-Point Bridge mode with the
Remote MAC Address of AP2.
3.
Verify the following parameters for all access points:
•
Verify that both access points are configured to operate in the same LAN network
address range as the LAN devices.
•
Only one access point is configured in Point-to-Multi-Point Bridge mode, and all the
others are in Point-to-Point Bridge mode.
