NETGEAR ProSafe WG102-500, Reference Manual

Page: 29 / 52

WG102-500, WGAP150 ProSafe 802.11g Wireless Access Point Reference Manual
Configuration 2-13
v1.0, February 2009
DHCP Relay Parameters
For the “DHCP Server Type ” setting (see Table 2-9 on page 2-10 ), when you select Relay , the
DHCP Relay Parameters screen displays.
The DHCP Server IP field specifies the IP address of the DHCP server
Static WEP Parameters
For the “Security Policy ” setting (see Table 2-9 on page 2-10 ), when you select Static WEP , the
Static WEP Parameters screen displays.
The configuration of the static WEP settings enables pre-shared WEP key encryption.
Authentication is not supported by this method. The security level of this method is not very
strong.
Table 2-11 shows the DHCP server settings.
Figure 2-9
Figure 2-10
Table 2-11. Static WEP Settings
Field Descriptions
Key Size This pulldown menu allows you to make one of the following selections:
•
40 bits (64-bit WEP) .
• 104 bits (128-bit WEP) .
Key Format This pulldown menu allows you to make one of the following selections:
•
ASCII .
• HEX .
FullManual.book Page 13 Thursday, January 29, 2009 10:12 AM