February 2014
NETGEAR, the NETGEAR logo, and Connect with Innovation are trademarks and/or registered trademarks
of NETGEAR, Inc. and/or its subsidiaries in the United States and/or other countries. Information is subject
to change without notice. © NETGEAR, Inc. All rights reserved.
NETGEAR, Inc.
350 East Plumeria Drive
San Jose, CA 95134 USA
Technical Specifications
Resolution
720p (1280 x 720)
Frame rate
30 FPS at 720p
Memory Buffer
30-second rolling buffer for pre-trigger event recording
Low-light capability
1 LUX (without IR LED)
Night vision
0 Lux -Range: 7M
Field of view
100 degrees diagonal
LEDs
2 bi-color (red/green) power and network LEDs
Power supply
1120 VAC to 5 VDC 2A with DC jack connector
WiFi
802-11n dual-band selectable - 2x2 with WPS 2.0
Mounting solution
• Shelf or desk
• Wall or ceiling (optional)
Connectors
• Power
• Network (over USB)
Multiple clients
Supports 4 simultaneous streams for multiple clients
API
PSIA
Troubleshooting
To determine the status of the camera, use the LEDs on the front of the camera.
Left LED
Right LED
Behavior
Red
Red
The camera has power and is booting.
Off
Off
The booting sequence is complete, there is no
WiFi link.
Off
Blinking green
The window is open for the camera to connect
with other WPS-enabled devices.
Off
Green
The camera is connected to a WPS-enabled
device.
Blinking green Solid green
The camera is transmitting data over the WiFi
link.
Wall Mounting
To wall-mount the camera, complete the following steps:
1.
Drill holes in the wall where you will wall-mount the camera.
Holes should be xxx inches (xxx centimeters) center to center.
2.
Install wall anchors in the holes.
Use pan head Phillips wood screws, 3.5 x 20 mm (diameter x
length, European) or #6 type screw, 1 inch long (U.S.).
3.
Insert screws into the wall anchors, leaving 3/16 in. (0.5 cm) of each
screw exposed.
HMNC100_IG.fm Page 2 Thursday, February 6, 2014 9:38 AM
