NETGEAR GS748T - ProSafe Smart Switch, Hardware Installation Manual, Page: 8 / 39

8 | Chapter 1: Introduction
GS748T Smart Switch Hardware Installation Guide
Features
The following list identifies the key features of the GS748T:
• Forty-eight 10/100/1000 Mbps auto-sensing Gigabit-Ethernet switching ports.
• Two SFP combo ports.
• Two dedicated 1000M SFP fiber ports.
• Full NETGEAR Smart Switch functionality.
• Full compatibility with IEEE standards:
• IEEE 802.3i (10BASE-T)
• IEEE 802.3u (100BASE-TX)
• IEEE 802.3ab (1000BASE-T)
• IEEE 802.3z (1000BASE-x)
• IEEE 802.3x (Full-duplex flow control)
• Autosensing and auto-negotiating capabilities for all ports.
• Auto Uplink™ on all ports to make the right connection.
• Automatic address learning function to build the packet-forwarding information table. The
table contains up to 8K Media Access Control (MAC) addresses.
• Store-and-Forward transmission to remove bad packets from the network.
• Full-duplex IEEE 802.3x pause frame flow control.
• Active flow control to minimize packet loss and frame drops.
• Half-duplex backpressure control.
• Per port LEDs and power LED.
• Internal power supply.
• Standard NETGEAR 7xx series chassis.
• NETGEAR Green product series power-saving features:
• Automatic power consumption adjustment based on the RJ-45 cable length.
• Per port automatic power down when the port link is down.