8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud
Management
Configure System Information
User Manual
79
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page
Access the switch off-network on page
.
The login page displays.
If the NETGEAR Business page displays, see
Register and access the switch with your
4.
Enter one of the following passwords:
•
After registration, enter the local device password.
By default, the local device password is
password
.
•
If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the local browser interface on
5.
Click the
Login
button.
The System Information page displays.
6.
Select
System > Management > Denial of Service > Auto-DoS Configuration
.
The Auto-DoS Configuration page displays.
7.
Select the Auto-DoS Mode
Enable
radio button.
When an attack is detected, a warning message is logged to the buffered log and is sent
to the syslog server. At the same time, the port is shut down and can be enabled only
manually by the admin user.
8.
Click the
Apply
button.
Your settings are saved.
Configure denial of service
You can select which types of denial of service (DoS) attacks the switch monitors and blocks.
To configure individual DoS settings:
1.
Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2.
Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page
Access the switch off-network on page
.
The login page displays.