8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud
Management
Maintain or Troubleshoot the Switch
User Manual
456
•
IP Address
. The source IP address that must be used when echo request packets
are sent. With this selection, the
IPv6 Address
field displays and you must enter the
IPv6 address that must be used as the source.
•
Interface
. The interface that must be used when echo request packets are sent. The
Interface
menu displays, but the only available selection from the menu is
Network
.
13.
Click the
Apply
button.
The specified address is pinged. The results are displayed below the configurable data in
the Results field.
Send an IPv4 traceroute
You can configure the switch to send a traceroute request to a specified IPv4 address or host
name. You can use this to discover the paths that packets take to a remote destination.
When you send a traceroute, the switch displays the results below the configurable data.
If a reply to the traceroute is received, the following message displays:
traceroute to x.y.z.w (x.y.z.w), maxTTL hops max, size byte packets
initTTL x.y.z.w (x.y.z.w) 0.000 ms * 0.000 ms
1 x.y.z.w (x.y.z.w) 0.000 ms * 0.000 ms
2 x.y.z.w (x.y.z.w) 0.000 ms * 0.000 ms
To send an IPv4 traceroute:
1.
Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2.
Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page
Access the switch off-network on page
The login page displays.
If the NETGEAR Business page displays, see
Register and access the switch with your
.
4.
Enter one of the following passwords:
•
After registration, enter the local device password.
By default, the local device password is
password
.
•
If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see