8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud
Management
Configure Switching
User Manual
168
5.
Click the
Login
button.
The System Information page displays.
6.
Select
Switching
> VLAN > Advanced > GARP Switch Configuration
.
7.
Select the GVRP Mode
Disable
or
Enabl
e radio button.
This selection specifies the global administrative mode for GARP on the switch. The
default is Disable, which causes the protocol to be inactive.
8.
Click the
Apply
button.
Your settings are saved.
Configure GARP ports
Note:
It can take up to 10 seconds for GARP configuration changes to take
effect.
To configure GARP ports:
1.
Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2.
Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page
Access the switch off-network on page
The login page displays.
If the NETGEAR Business page displays, see
Register and access the switch with your
.
4.
Enter one of the following passwords:
•
After registration, enter the local device password.
By default, the local device password is
password
.
•
If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see