Model DS104/106/108/116 Dual Speed Hub Installation Guide
Install the Hub on a Wall
If installing the hub on a wall, make sure you have a Phillips screwdriver.
To install the hub on a wall:
1.
Set the mounting screws and anchors (supplied with the wall mount
hardware) in the wall.
2.
Using the slots on the bottom of the hub, hang the hub on the wall.
3.
Connect the power cord(s) first to the power entry receptacle on the
hub rear panel and then to the wall.
Set Normal/Uplink Push Button
The Normal/Uplink push button on the front panel of the hub allows you to
select the Uplink (MDI) or Normal (MDI-X) position for port 4 on the Model
DS104 hub, port 6 on the Model DS106 hub, port 8 on the Model DS108 hub,
and port 16 on the Model DS116 hub. All other ports are wired Normal for
direct connection to PCs.
Select Normal if connecting a PC, server, or router to the port. Select Uplink if
connecting a hub or switch. The Normal/Uplink push button eliminates the need
to use a crossover cable.
Caution: 100 Mbps operation requires the use of Category 5 UTP
wiring with 100 Mbps certified connectors. NETGEAR highly
recommends using Category 5 cable so your network can operate at
either 10 or 100 Mbps.
Connect a PC to the Hub
Normal/Uplink
10M Link Activity
100M Link Activity
Power
Collision
9097FA
Summary of Contents for DS104
Page 1: ......
