Statement of Conditions
In the internal function, and/or reliability, NETGEAR reserves the right to make changes to the products described in
this document without notice. NETGEAR does not assume any liability that may occur due to the use or application
of the product(s) or circuit layout(s) described herein.
Federal Communications Commission (FCC) Compliance Notice:
Radio Frequency Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the
receiving antenna, (2) Increase the separation between the equipment and receiver, (3) Connect the equipment into an
outlet on a circuit different from that to which the receiver is connected, (4) Consult the dealer or an experienced
radio/TV technician for help.
Federal Communications Commission (FCC) Radiation Exposure Statement
To ensure the compliance with the FCC RF exposure requirement for safety, make sure that the antenna is installed
with separation distance of at least 25 cm (10 in) from a person. The antenna shall not be colocated with other
transmitting devices.
Note: To meet FCC regulations, the system must be installed as shown in the diagrams. Substitution of cables and
access point provided and/or any modification to any of the components of this system will void the user's right to
operate it.
Check http://www.NETGEAR.com/go/antennas_fcc for a list of FCC approved devices.
Use of this booster with any other devices is strictly prohibited by the FCC.
12
To ensure compliance with the FCC's RF Exposure requirements for safety, all omni- directional antennas must
be installed to provide a separation distance of at least 20cm from a person.
The panel antennas (Netgear part numbers ANT24D12 and ANT24D18) must be fixed mounted on a permananet
structure to ensure a separation distance of at least 50cm from all persons. The panel antennas can only be used
for point-to-point applications and may not be used for point-to-multipoint applications.
The antennas shall not be co-located with other transmitting devices.
Note: To meet FCC regulations, the system must be installed as shown in the diagrams. Substitution of cables and
access point provided and/or any modification to any of the components of this system will void the user's right to
operate it.
Check http://www.NETGEAR.com/go/antennas_fcc for a list of FCC approved-antennas.
Use of this booster with any other devices is strictly prohibited by the FCC.