10 of 18
Technical Support Guide
© NetComm Wireless 2017
5
Navigate to the
AP > Repeater
page:
Important
–
The
AP > Repeater Settings
are different for the AP (see section
WDS Link settings for Access Point
, below) and the
Repeaters (see section
Configure AP WDS Link settings
, below).
4.a Configure Repeater WDS Link settings for Access Point (AP)
a
For only the WDS Access Point, the MAC addresses
of the other Repeater NP731 devices must each be
referenced to a numbered
WDS Link
.
b
This referencing is accomplished using the
WDS
Profile
drop-down selector in conjunction with the
Remote AP MAC Address
field, see image on right.
Item
Setting(s)
Notes
Repeater Type
WDS
WES
Use same settings for the AP and all Repeaters.
WDS Profile
drop down list
WDS Link 1
(MAC address of 1
St
repeater device)
1. Select
WDS Link 1
from the drop-down list,
2. Enter the MAC address* of the first Repeater device
into the
Remote AP MAC Address
field, see below,
3. Click the
SAVE
button
4. Repeat these steps for the other Repeater devices.
WDS Link 2
(MAC address of 2
nd
repeater device)
1. Then select
WDS Link 2
from the drop-down list,
2. Enter the MAC address* of the second Repeater
device into the
Remote AP MAC Address
field, see
below,
