o
Data Bits
are the number of bits in a transmitted data package.
o
The
Stop bit
follows the data and parity bits in serial communication. It
indicates the end of transmission.
•
Click the
MTTTY
Connect
button.
•
Remove and reapply power to your SB72 EX.
•
The SB72EX factory application will boot.
5.
Run Telnet by typing: “telnet 10.1.1.79 24” after the prompt, and press the Enter key. Note
:
This
assumes a port number of 24. You must replace this port number with the listening port number
that you assigned in the “Device Connection Settings (TCP mode)” section. Remember to
substitute your IP Address for our example IP Address (i.e.10.1.1.79).
6.
At this point, anything you type in the Telnet window should appear in the serial terminal window
and vice versa.
SB72EX User's Manual, 350030-001
Page 18
electronic components distributor
