Install Hardware
29
3.5. Fan Modules
The system incldues four fan modules.
TO AVOID SEVERE SYSTEM OVERHEATING, ALL PROCEDURES ON THIS SEC-
TION SHOULD BE PERFORMED WITHIN 10 MINUTES.
3.5.1. Removing a Fan Module
To remove a fan module, do as follows:
1. Push the fan module handle (A) up to the open position.
2. Press and hold the locking latch (B) lever.
To avoid damaging the fan, support the module whith the second hand when
pulling out of the system
3. Pull the fan module out of the system.
Figure 3.11. Removing Fan Module
A
B
1
2
3
3.5.2. Installing a Fan Module
To install a fan module, do as follows:
To avoid damaging the fan, support the module whith the second hand when installing
to the system.
1. Insert the fan module into the system. Make sure the module is flush with the system and the
locking latch lever (B) is locked in place.
Summary of Contents for Aeon J460 M2 JBOD
