•
If version 1.6 or later of the StorageGRID Webscale Appliance Installer is included with the
controller, this display shows HO, followed by a repeating sequence of two digits.
HO -- IP address for Admin network -- IP address for Grid network
HO
In the sequence, the first set of numbers is the DHCP-assigned IP address for the controller's
management port 1. This address is used to connect the controller to the Admin network for
StorageGRID Webscale. The second set of numbers is the DHCP-assigned IP address used to
connect the appliance to the Grid network for StorageGRID Webscale.
Note:
If an IP address could not be assigned using DHCP, 0.0.0.0 is displayed.
•
If version 1.3 of the StorageGRID Webscale Appliance Installer is included with the
controller, this display shows IM.
Note:
DHCP IP addresses are not supported by version 1.3 of the StorageGRID Webscale
Appliance Installer.
Viewing boot-up status and reviewing error codes on the
controllers
The seven-segment display on each controller shows status and error codes when the appliance
powers up, while the hardware is initializing, and when the hardware fails and must back out of the
initialization. If you are monitoring the progress or troubleshooting, you should watch the sequence
of the codes as they appear.
About this task
The status and error codes for the E5600SG controller are not the same as those for the E2700
controller.
Steps
1. During boot-up, view the codes shown on the seven-segment displays to monitor progress.
2. To review error codes for the E5600SG controller, see the seven-segment display status and error
code information.
3. To review error codes for the E2700 controller, see the E2700 controller documentation on the
Support Site.
Related references
E5600SG controller seven-segment display codes
Related information
NetApp Documentation: E2700 Series
E5600SG controller seven-segment display codes
The seven-segment display on the E5600SG controller shows status and error codes while the
appliance powers up and while the hardware is initializing. You can use these codes to determine
status and troubleshoot errors.
When reviewing status and error codes on the E5600SG controller, you should look at the following
types of codes:
Installing the appliance hardware | 27
Summary of Contents for StorageGRID Webscale 10.4
Page 2: ......
