ses.status.temperatureWarning
Description
This message occurs when the indicated disk shelf temperature sensor reports a temperature
that is close to exceeding the specifications for the disk shelf or its components.
Corrective action
1. Verify that the ambient temperature where the shelf is installed is within the vendor's
equipment specifications by using the
environment shelf [adapter]
command,
and check that airflow clearances are maintained.
2. If the same disk shelf also reports fan or fan module failures, correct that problem now.
3. If the problem is reported by the ambient temperature sensor (located on the operator
display panel), verify that the connection between the disk shelf and the panel is secure,
if possible.
4. If the problem persists, and if the shelf has multiple temperature sensors but only one
exhibits the problem, replace the module that contains the sensor reporting the error.
5. If the problem persists, contact technical support.
Monitoring the disk drives or carriers
You can monitor the health of the disk drives or carriers by familiarizing yourself with the location
of the LEDs, their meanings, the H1 shelf mode if applicable, and the error messages that can
occur when there is a problem.
Location of the disk drive or carrier LEDs
The LEDs on the disk drive or carrier indicate whether it is functioning normally or there are
problems with the hardware.
The following illustration shows the location of the LEDs on the front of a disk drive used in a
DS2246 disk shelf.
600
GB
1
2
DS4243, DS2246, DS4486, and DS4246 Installation and Service Guide
37
Monitoring disk shelf components
