11/50
Pl
ea
se
n
ot
e
th
at
a
ll
da
ta
a
nd
il
lu
st
ra
tio
ns
a
re
su
bj
ec
t t
o
er
ro
r,
ch
an
ge
a
nd
o
m
iss
io
ns
w
ith
ou
t n
ot
ic
e.
CO
RS
IG
HT
O
pe
ra
tio
na
l M
an
ua
l -
re
v.
2.
0_
10
_2
01
6
Usage Notes
Handle carefully
Do not drop the equipment or allow it to be subject to strong impact or vibration, as such action may
cause malfunctions. Further, do not damage the connection cable, since this may cause wire breakage.
Environmental operating conditions
Do not use the product in locations where the ambient temperature or humidity exceeds the
specifications. Otherwise, image quality may be degraded or internal components may be adversely
affected. In particular, do not use the product in areas exposed to direct sunlight. Moreover, during
shooting under high temperatures, vertical stripes or white spots (noise) may be produced, depending
on the subject or camera conditions (such as increased gain). However, such phenomena are not
malfunctions.
Check a combination with the lens
Depending on the lens and lighting you use, an image is reflected as a ghost in the imaging area.
However, this is not because of a fault of the camera. In addition, depending on the lens you use, the
performance of the camera may not be brought out fully due to deterioration in resolution and
brightness in the peripheral area, aberration and others. Be sure to check a combination with the
camera by using the lens and lightning you actually use. When installing a lens in the camera, make
sure carefully that it is not tilted. In addition, use a mounting screw free from defects and dirt.
Otherwise, the camera may be unable to be removed. Install a next lens; its dimension of protrusion
from bottom of the screw is equal to or less than 10 mm. If a lens does not stand to this condition, it
might not be installed to this camera.
Do not shoot under intense light
Avoid intense light such as spot lights on part of the screen because it may cause blooming or smears. If
intense light falls on the screen, vertical stripes may appear on the screen, but this is not a malfunction.
Dropping Frames
Depends on your PC or Gigabit Ethernet interface board configurations, images may not be captured
properly (e.g. dropping frames). In this case, change to frame rate setting lower.
