iTap GigaBit Dual Port Aggregator
14
Connecting the Management Port
To use the remote interfaces you must connect the Management Port to the
network.
To connect the iTap Management Port:
1. Connect a CAT5 cable to the Manangement Port as shown in Figure 9.
2. Connect the other end to a network switch or hub.
Figure 9:
Connecting the Management Port
Connecting to the Network
The iTap comes with two network cables ready for iTap installation.
To connect the iTap to your network:
1. Connect Network Port A to the appropriate network device using the cables
supplied with your iTap.
2. Connect Network Port B to the appropriate network device using the cables
supplied with your iTap.
3. Verify that the iTap Network Ports are cabled in-line between two devices.
Management
Port
RS232
To network switch or hub