NESTOR MARTIN WOODBOX MQ33, Instructions Manual, Page: 9 / 26

9
SETTING UP ON THE STAND
Procedure
•
Place the stand in the prepared position.
•
Place the stove on the stand using a lift or sharing the weight between several people.
•
Unscrew the 2 fixing screws from the control panel and remove it (photo 1).
Photo 1 Photo 2
•
Pass the bolt through the flue of the outside air intake system of the bench stand and put it into the mounting
hole using an Allen key.
•
Using the latch key, bring the nut in front of the hole and screw it in with the Allen key (Photo 2).
•
Replace the control panel and the base cover using the screwdriver or screw gun.
Warning: the tighter the screw is, the more resistance there will be in moving the stove.
MOTOR AND RECEIVER
To install the motor and receiver, proceed as follows:
1.
Remove the control panel (2 screws)
2.
Pull back the strap of the magnet then wedge
the muff of the motor against the magnet.
3.
Remove the cast iron back.
4.
Place the receiver in its stand and place it on
the base.
5.
Link up the motor and the receiver with the
cable, by passing the cable from the back to the
front. The rectangular hole is provided for this.
Magnet
Strap
Rectangular hole