8
9
NC-1000 -
installation manual
8
9
3. Mounting of the frame
NC-1000 frames are delivered separately protected with their own transportation pallet. In the
installation site the frame is shifted to its place and fastened to the floor. Before fastening the
frame shall be adjusted directly from its adjusting feets. If necessary, the frame can be also
fastened to the wall from the top with an optional wall mounting kit.
4. Earthing of the frame
If outdoor cables including metallic elements are brought to the frame, the frame shall earthed.
Make the earthing by connecting the frame to the equipotential or earthing terminal of the
equipment room by using min. 16 mm2 copper wire. Adjust the earthing bar of the frame to the
suitable height and connect the copper wire to the bar.
5. Termination of outdoor cables to NC-1000 frame
There are two principle ways of outdoor cable termination:
Outdoor cables are jointed to pigtail cables within the NC-1000 frame.
1.
Outdoor cables are jointed to pigtail cables outside the NC-1000 frame within a joint closure or a splice
2.
cabinet.
These termination methods are handled separately in the following chapters.
5.1 Termination of outdoor cables to pigtail cables within the NC-1000 frame
5.1.1 Installation of the splice tray holder
Take the splice tray holder with its mounting accessories from its package and turn it in the right way for
•
mounting to the inner frame.
Install the basket nuts of the splice tray holder to the followig mounting places of the inner frame:
•
upper nuts:
43 cm from the bottom of the inner fame
lower nuts:
23 cm from the bottom of the inner fame
Fix the splice tray holder with its screws to the inner frame.
•
43 cm
23 cm
