LUMINA BOTTOM-LOAD DISPENSER USER GUIDE | 11
10
4.0 Dispenser Care
6. Attach red air connector to inlet on cap.
The connection should be tight and secure.
7. Slide bottle inside cabinet, ensuring no tubes are
pinched or kinked. Close cabinet door.
8. Place cup on cup stand. Lift red safety lever,
and simultaneously press and hold the
hot & cold levers for one second, then release.
Priming has started when you see flashing
dispensing light. After two minutes, the light will
stop flashing and dispenser is ready for use.
1. The solid red light will indicate the bottle is
nearly empty.
2. Bring in a new, full 5-gallon bottle of water over
to your dispenser. Remove entire cap by holding
tab firmly, peeling halfway around bottle neck
and pulling upwards.
3. Remove empty bottle from cabinet and
disconnect red air connector by pulling upwards.
4. Lift up clamping lever to unlock, release cap,
and pull the lower cartridge upwards. Let water
drain from tube, then remove from bottle.
5. Lower dip tube into new, full bottle and secure
cap onto bottle opening. Press down on
clamping lever to lock.
4.1 Bottle Change
