1. Power switch
2. Dimmer dial
3. Light panel
4. Angle lock
5. Pressure nut
6. Shoe
7. Ventilation holes
8. Serial number
9. External brightness controller input
10. Power socket
4. Using the connectors
__
•
In cameras with LCD placed near the hot shoe, so as not to block
the opening of the display, remove the pressure nut (Fig. 10) and
put the same shoe into the provided hole in the connector of the
battery adapter, or use a small connector contained in the set.
•
When using the light on the DSLR camera so as not to block
the viewfinder put the same shoe in the right hole or loosen the
pressure nut (Fig. 10) and turn the connector of the battery adapter
by 90° (so that the battery adapter was placed on the side of the
lamp, by the external controller inputs).
NOTE
: After you made adjustments, tighten back the pressure nut.
5. Smooth brightness adjustment
__
•
Setting the dimmer dial to "minimum" reduces power consumption
to zero (there is no the need to use switch after every shot to turn
off the light).
•
The light does not flicker in the whole range of adjustment.
9. Contraindications_
____
•
Do not connect a higher voltage than specified.
•
Do not block ventilation holes.
•
Do not wash the housing with alcohol or other solvents.
In the case of water damage, disconnect the power, and do not turn on
until dry.
7. External brightness controller
__
•
When connecting the controller, light should be turned off (with a
switch) or disconnected from the power source - otherwise there is
a possibility of damaging the lamp.
•
After connecting the external controller, the internal dial becomes
inactive (when the NRC-03 is connected, the adjustment can be
done only by using the controller).
•
After connecting the NRC-03 controller to L-48u/L-42u the color LED
stays inactive.
Summary of Contents for L-48U
Page 1: ...1 User s manual...
