1. Always unplug machine when not in use, before inserting or removing parts, and before
cleaning.
2. NEVER immerse Motor Body in water or other liquid. Wipe Motor Body with a clean cloth
dampened with water and a mild detergent. Do not use harsh or abrasive cleaners on
Motor Body as this will damage the finish.
3.
Wash all parts except Motor Body in hot soapy water, rinse and set aside. Use care
when handling the sharp blades.
4. Rinse parts with clean hot water, then dry parts thoroughly, especially the Cutting plates
and Blade.
5. NOTE: REMOVABLE METAL PARTS ARE NOT DISHWASHER SAFE. Dishwasher
detergents may cause pitting and corrosion. Wash by hand in hot soapy water.
6. The Blade and Cutting Plates should be coated with cooking oil after washing and drying.
Wrap in grease-proof paper or plastic bag to prevent corrosion (rust).
7. Store appliance in a dry place.
1.
Make sure all parts of appliance are
clean. If cleaning is necessary follow
Cleaning Instructions on
page 9.
2.
Loosen Threaded Ring Nut with
Wrench and remove by turning
counter-clockwise. Remove Plate
and Blade and set aside.
2.
Place plastic Base Plate (13) and
Sausage Cone (15) on end of Feed
Screw.
3.
Thread Ring Nut (11) onto to end of
the Grinder Head by hand, turning
clockwise until tight.
4.
IMPORTANT: Make sure Grinder Head (7) is in a vertical position and securely locked in
place by turning Locking Knob (4) clockwise in the direction indicated on Motor Body
until tight.
5.
Insert Food Hopper on top of Grinder Head.
8
NESCO
®
FG-350 Food Grinder
1. Carefully unpack unit and examine all
packaging to make sure all parts are
included (see page 4)
2
.
Make sure Switch is “off” (O) and power
cord unplugged before assembling.
3. Turn Locking Screw (1) counter-clockwise
several turns. Insert Grinder Head into
Attachment Fitting as shown in (2) until
seated (Fig. 2). Rotate Grinder Head
counter-clockwise (3) to lock in place.
Turn Locking Knob (1) clockwise until fully
seated to securely lock Grinder Head into
Motor Body (Fig. 3). IMPORTANT: Make
sure Grinder Head is in a vertical position
and securely locked in place.
4. Place Feed Screw into Grinder Head,
long end spindle first; turn it slightly
until it is set into Attachment Fitting
on Motor Housing.
5. Position Blade onto Feed Screw
shaft so knife edge is facing away
from the Feed Screw and seated
over ‘square’ shoulder of Feed
screw. Make sure blade is seated on
square shoulder of feed screw or
meat will not grind properly and
Cutting Plate may get permanently
damaged.
6. Place the desired Cutting Plate over
end of Feed Screw and against
Blade. NOTE: Make sure the notch
faces down and lines up with the ’key’
in Grinder Head and seated against
Blade.
7. Thread Ring Nut on Grinder Head and turn clockwise until tight.
8. Place Food Hopper on top of Grinder Head.
NESCO
®
FG-350 Food Grinder
5
Assembly Instructions
Cleaning Instructions
Sausage Maker Assembly