Instructions
1.
When pouring water into the kettle, the water level must be kept within the range
of the maximum and minimum water levels set by the scale.
2.
Place the kettle base firmly on the stand, insert the plug into the socket and switch
it on. The water will heat up when the indicator light is on. When the water is
boiling the switch will bounce up, the indicator light will go out, and the kettle will
automatically cut off the electricity.
Notes
•
Always ensure that there is water in the kettle when it is plugged in. Do not
release the lid while the water is boiling. The lid must be closed before boiling.
•
If water is found on the table or under the kettle, it is a normal phenomenon
due to the condensation of water vapour.
Caution
1.
This kettle should be used with a residual current device (safety switch) to lessen
the risk of scalding or other injury from hot water that may be ejected if the
heating element ruptures.
Disregard this marking if your home is fitted with a residual current device (safety
switch).
2.
Do not operate the kettle on an inclined plane. Do not operate the kettle unless
the element is fully immersed. Do not move while the kettle is switched on.
3.
To prevent damage to the appliance, do not use alkaline cleaning agents when
cleaning, use a soft cloth and a mild detergent.
4.
Do not let the power cord hang over the edge of a bench or touch hot surfaces.
5.
Be sure not to overfill the kettle with water, so as to prevent it from overflowing
when the water boils. Always ensure that the cover is in place when water is
being heated up.
6.
Do not place the kettle, the stand, the power cord or the plug in water.
7.
Do not use the appliance if the stand, power cord or plug of the kettle is
damaged. To avoid danger, these things must be replaced by the manufacturer
or their maintenance department.
8.
Use caution when pouring water from the kettle as boiling water and steam will
scald.