Neptune R450 MC, Installation And Maintenance Manual

Page: 36 / 104

Installation of the R450 MC
22 R450 Mini Collector Installation and Maintenance Guide
Activating the R450 MC System
Once you have all the kit items in place, attached, and mounted, you can
activate the R450 MC system.
Activating the Solar Power System
To activate the battery, complete the following steps.
1 Open the door of the battery box.
2 Turn the two breakers to the ON position.
3 Close the battery box with locking key.
This should activate both the battery box and the R450 MC.
Figure 27 Activating the Solar System
4 Open the R450 MC by removing the security Torx screws in the
following pattern: 4, 3, 2, 1. See Figure 28.
To close the R450 MC, replace the security Torx screws in the
following pattern: 1, 2, 3, 4. See Figure 28.
5 Watch the LED located in the lower right corner of the radio
module.
There is approximately a 30-second delay before the LED activates.
6 Configure the GPRS modem. See “Configuring the R450 MC” on
page 29.
Figure 28 Security Torx Screws
7 Configure the USB flash drive using the N_SIGHT R450 host
software (version 1.6 or later). If configuring multiple USB flash
drives, be sure to label them accordingly.
8 Configure the R450 MC using the configured USB flash drive. See
“Configuring the R450 MC” on page 29.
Breaker
Security Torx
screws (4)
4
3
2
1
If the R450 MC is an Ethernet version, skip step 6.
The configured USB flash drive contains information that is
unique to each R450 MC. Do not inadvertently switch them
during R450 MC configuration.