N e p t u n e
™
1 . 2 5 H P P o o l P u m p M o t o r
I n s t a l l a t i o n a n d O p e r a t i o n M a n u a l
16
Press the
MENU/ENTER
button within the time frame to confirm the operation. The LCD screen then
displays the following message for two (2) seconds and returns to normal operation.
When the keypad is locked, the UI displays the above message anytime the
MENU/ENTER
button
is pressed.
Unlock the Keypad
With the motor in
Standby Mode
, press the
MENU/ENTER
button and hold the button down for
three (3) seconds. The LCD screen flashes and displays the following message for ten (10) seconds.
Note
: If the control does not detect a button press within the time frame, the request to unlock the
keypad is cancelled.
Press the
MENU/ENTER
button again to confirm the operation. The LCD screen displays the
following message for two (2) seconds and then returns to normal operation.
Operational States
The table below describes the operational states for the motor.
State
Description
Power On
Initialize the motor and all communication ports. The motor is ready to run.
Standby
The motor is waiting for a key press or a scheduled event to run the pump.
Run
The pump is running in response to a timer, a manual override, a manual
pool cleaning, or a low temperature event.
Remote
The pump is operating under commands it receives from a central controller.
The UI is bypassed in this operational state.
Fault
The pool pump moves into this state in response to the detection of a fault
condition in either the motor or the control.
Menu Setup
Pressing the
MENU/ENTER
button while in Standby shifts the motor to the
Menu Setup state in which the motor can be configured.
Power Loss
If the control detects a low voltage condition, it prepares the motor for a
possible power loss.
