Neptune Technology R450, Installation And Maintenance Manual

Page: 51 / 144

1. Wait about five minutes after you have powered on the
R450 DC.
2. With an R450 MIU, position the Neptune magnet against the
left side of the MIU directly in line with the Neptune logo, as
shown in Figure 32.
3. Swipe the MIU bringing the magnet from the side and around
the corner to the top. See Figure 32.
Figure 32 – Activating the MIU
4. When swiped, an email will be sent to the email address that is set
up in the host software. See the following example.
Figure 33 – Email Sent from R450 DC
l
Make sure the email comes from the R450 DC that you are
installing.
l
If you do receive an email, continue to the instructions outlined
in "Securing the R450 DC" on page 29.
l
If you do not receive an email, continue to the instructions
outlined in "If No Email is Received".
If No Email is Received
If you do not receive an email, do the following
1. Check to see if the Midland Radio is getting power by verifying
that the POW light is on.
R450 Data Collector Installation and Maintenance Guide 31
Chapter 3: Installation of the R450 DC