POC-400 Series
75
4.6
Power On after Power Failure
This option defines the system
’
s behavior when DC power is supplied.
Value
Description
S0
–
Power On
System is powered on when DC power is supplied.
S5
–
Power Off
System is kept in off state when DC power is supplied.
When you want to use the AT-mode remote on/off control function, you have to set
this option to “
S0
–
Power On
”. Please refer to
AT-mode remote on/off control function.
To set “Power On after Power Failure” option:
1.
Press
F2
when the system boots up to enter the BIOS setup utility.
2.
Go to
[Power]
.
3.
Set the
[Power On after Power Failure]
option to the desired setting.
4.
Once set, press
F10
to save setting and exit.
Summary of Contents for POC-400 Series
Page 1: ...Neousys Technology Inc POC 400 Series User Manual Revision 1 0...
Page 4: ...Table of Contents 4 GetStatusPoEPort 97 EnablePoEPort 98 DisablePoEPort 99...
Page 16: ...POC 400 Series 16 1 3 Dimension 1 3 1 Superior View 1 3 2 Front Panel View...
Page 17: ...POC 400 Series 17 1 3 3 Bottom View...
