USB/Power In
TV Out
SD
12
(1)Hold up the negative toward the light.
As you look through the negative, you
should be able to read the small negative
numbers normally (not a mirror image).
(2) Open the negative holder as shown in image (2)
above. With the negative holder laid open
place the negative into holder so the notches
line up with the notches on the holder, and
that each image being scanned fits in the space
provided. This may take a little practice (five
minutes) but once you have aligned 2/3 rows
of negatives you will understand!
Note:
Handle negatives with care. Any dust,
scratches or finger prints will show up on your
saved images. If possible use cotton gloves
when handling negatives. It is recommended
to use compressed air to remove any dust on
the negatives.
This is not included with the film scanner but
can be purchased from an office supply or
electronics retailers.
(3)Close the negative holder and press the edges
so that it locks in place. It works best with the
negative strip occupying the middle sections
of the negative holder.
(4)Insert the negative holder into the slot on the
side of the film scanner as shown by the arrow
pointing into the scanner (on the left side of
scanner). As you then move through the
negative strip to scan them all you will push
the negative holder through the main body
(right direction) and the holder will exit the
main body on the right hand side (as pictured
in image (4) above.
If there are pictures that you have scanned but would like to delete, then
select playback mode from main menu, scroll through images using the
left/right arrows, select chosen image; when you are viewing chosen
image press Menu button and scroll through options until you see Delete.
Select Delete and then press OK. The image will be removed from the
SD memory card.
