13
DOC42-00027-C Integrator's Guide.doc
Via IR Remote
There are three power buttons on the IR remote.
Power Toggle – Changes power state from current state
Power On – Always turns on, regardless of current state
Power Off – Always goes to standby, regardless of current state
Standby Mode
When in Standby Mode, all outputs are virtually disconnected, and volumes are
set to 0. At this state, the switch can still execute commands from the serial port,
just in case your control system or remote did not turn it on first. It will appear
to stay in the standby state however even if routes are completed.
In Standby, any command received will not be saved. Thus, when the switch is
powered back on, the most recent switch state and volume levels before the unit
is powered off will be reloaded.
Signal Routing Using the Front Panel or IR
When powered on, three buttons are enabled to start a switching command.
The
basic routing sequence for audio and/or video uses 4 button sequence. The panel
will not allow you to select inputs or outputs that do not exist.
The input number is
x
and the output number is
y
.
Routing Function
Key Sequence
Switch video and audio from input x to output y
INPUT
x
OUTPUT
y
Switch input x to all outputs
INPUT
x
OUTPUT 0
Disconnect output y
INPUT 0 OUTPUT
y
Switch component video x to output y
VIDEO1*
x
OUTPUT
y
Switch composite video x to output y
VIDEO2
x
OUTPUT
y
Switch analog audio x to output y
AUDIO1**
x
OUTPUT
y
Switch digital audio x to output y
AUDIO2
x
OUTPUT
y
*In front panel, this is labeled as VIDEO
**In front panel, this is labeled as AUDIO
