4
Operating Instructions
DO NOT exceed the maximum weight limits for the worktop. These weight limits are set out on page 7 of this Manual.
DO NOT move the Unit when the Top Surface and Shelves are fully loaded, or with the Castors locked. Any loads on the
unit should be placed as equally and centrally as possible with sufficient clearance underneath the worktop.
DO NOT load the bottom shelf with items stacked higher than the shelf back-board.
The unit can now be raised to the required height for your preference. It is recommended that the power is switched off
at the mains supply (if possible) when the unit is in prolonged periods of static use at the required height.
If any out-of-sync problems arise with any subsequent adjustment to the unit’s height, the initialisation process should be
repeated after first disconnecting and re-connecting the power supply lead from the control box.
Adjustment of the table height
.
Push one of the height adjustment buttons located on the Desk Control Panel at the front of the unit (E)
Push for Up or
Push for Down
The unit will slow and then stop when the travel limit in either direction is reached.
Please note the motors have a slow start and stop function built into the programme.
Locking and Unlocking the Castors
To lock the Castors, press down on the lever with your toe.
To unlock the Castors, lift them up with your toe.
Synchronisation of Units
The Maximum number of tables that can be linked is 4 Units
All Units to be linked will require an individual Power Supply
All Units to be linked will require a Serial Linking Cable
The Serial Linking Cable will be used to connect between each Control Box
For full details on synchronisation please refer to your service provider.
Rev
1A
Date
8
th
April 2014
Summary of Contents for NPEHA1075
Page 8: ...Rev 1A Date 8th April 2014...
