Neomatica LLC. Vehicle tracker ADM333BLE GLONASS/GPS. Ver. 1.2 dd 13.07.2019
27
TEMPRANGE X, A, B
Parameter X
– device number (from BLESENSOR sensors list).
Parameters A and B
– limits of the acceptable temperature range.
Parameters A and B can be omitted- current range will be displayed.
Setting the acceptable humidity range.
HUMIDRANGE X, A, B
Allows to set the acceptable humidity range of the sensor.
Parameter X - device number (from sensors list).
Parameters A and B
– limits of the acceptable humidity range.
Parameters A and B can be omitted- current range will be displayed
Setting the acceptable illumination range.
LIGHTRANGE X, A, B
Parameter X
– device number (from BLESENSOR sensors list).
Parameters A and B - limits of the acceptable illumination range.
Parameters A and B can be omitted- current range will be displayed
Setting upper and lower sensor states. When there is a changeover between the states an
extra point is drawn.
ANGLERANGE X, A, B, C, D
X - device number (from BLESENSOR sensors list).,
A, B
– lower and upper limits for “lower” sensor state.
C, D
– lower and upper limits for “upper” sensor state.
6.3.4 Adding BLE fuel level sensor in a manual mode, viewing added
sensors list
«
BLEFUEL
» command allows to add sensors addresses as well as to view the list of added
sensors. No need to enter a colon when entering an address.
BLEFUEL X,Y
– add address Y to cell X, where X=0..2;
BLEFUEL X,0
– clear cell X; where X=0..2;
BLEFUEL Y
- add address Y to the end of the list,
BLEFUEL 0
– clear the list.
BLEFUEL
- display the list of addresses added to the tracker.
