Programming
The following parameters can be edited and stored to setting A or B:
- Preset select
Preset 1 (Mellow sound with far Distance setting. Cabinet simulation is turned off.)
Preset 2 (Closer Distance setting with the 122 cabinet simulation turned on.)
- Drive Intensity
in 5 steps (off,1,2,3,full)
Settings are stored to flash memory so that there's no reprogramming necessary on power up.
1.
Power up the mini Vent while holding the Slow/Fast switch for 3 seconds
This enters the edit routine, effect will be switched on and Slow Speed is selected
2.
Set the A-B switch on the back according to the setting you want to edit
3.
The Speed LEDs reflect the parameter settings. Lo LED represents "Preset 1", Hi LED represents
"Preset 2". The Drive intensity is indicated through flashing or constant glowing.
Here's a list of all possible settings:
Preset 1, Drive off (Lo LED blinks 1x/sec, Hi LED off)
factory default for A
Preset 1, Drive 1 (Lo LED blinks 2x/sec, Hi LED off)
Preset 1, Drive 2 (Lo LED blinks 3x/sec, Hi LED off)
Preset 1, Drive 3 (Lo LED blinks 4x/sec, Hi LED off)
Preset 1, Drive full (Lo LED constantly on, Hi LED off)
Preset 2, Drive off (Lo LED off, Hi LED blinks 1x/sec)
Preset 2, Drive 1 (Lo LED off, Hi LED blinks 2x/sec)
Preset 2, Drive 2 (Lo LED off, Hi LED blinks 3x/sec)
Preset 2, Drive 3 (Lo LED off, Hi LED blinks 4x/sec)
Preset 2, Drive full (Lo LED off, Hi LED constantly on)
factory default for B
4.
To get UP on the list press the Bypass switch repeatedly, to get DOWN on the list press the Slow /
Fast switch.
5.
Toggle the A-B switch if the other memory shall be edited too and repeat the previous steps
6.
When editing is finished press Bypass and Slow/Fast simultaneously and hold for 2 seconds.
Settings will be stored and the mini Vent returns to play mode (effect on, slow speed).
Warranty terms
Neo Instruments extends a warranty covering all verifiable defects in material and workmanship for a
period of 12 months from the date of original purchase. Statutory warranty rights remain unaffected
hereby. The warranty covers the remedying of manifest defects by replacing or repairing defective
parts. Any other claims, in particular those for a reduction in price or cancellation of contract, may
only be made after an attempt to rectify the defect or deliver a replacement has failed.
The warranty does not cover damage incurred during transit, as well as damage caused by non-
compliance with the operating manual and improper or negligent handling of the device. Beyond that,
the warranty does not cover defects or damage caused by acts of God (including but not limited to
lightning, floods, etc.) or other external influences, as well as mechanical damage or flaws that are
not attributable to manufacturing defects. If defects occur during the warranty period, please contact
us at the following address:
NEO Instruments
Flemingstrasse 20-22
D-36041 Fulda
+49 (0)661-9619805
www.neo-instruments.de
© 2013 Neo Instruments All Rights Reserved