background image

 

- 9 - 

 

Chapter 3 - Operation

 

 

3.1 Operation

 

 

SELECTING THE IPOD

 

 

To select the iPod from the radio, press the button that would normally activate the factory CD 
changer.    This  button  varies  by  vehicle  manufacturers.    In  some  applications  (using 
configuration #8) the iON is accessed like an XM receiver. In these cases  you will press the 
appropriate activation button.  Some radio models require pressing the “Seek >” button once, 
after pressing the CD button.  Yet, it may also be necessary to press Play on the iPod itself to 
begin playback.  In some cases, if it is the first time selecting the iPod from the radio it may 
take up to three minutes for the iON to initialize. 

 

CONTROLLING THE IPOD FROM THE RADIO

 

 

With  the  iON  interface,  the  radio  will  control  the  iPod  as  if  it  were  a  factory  CD  changer.  
Therefore, operation will be done by using the same buttons you would use to control a factory 
CD changer.  For more details on your particular radio, consult your vehicle’s owner’s manual.  

 

 

 

The iON interface  allows  you  to skip  songs  forward  and  backwards  and  also  to  fast forward 
and  rewind  through  a  particular  song.    In  general,  most  radios  will  utilize  “seek”  or  “track” 
buttons to control these functions. 

 

CONTROLING THE IPOD FROM THE IPOD

 

 

The iON interface allows you to keep full control of the iPod from the click wheel.  You can 
browse files and change playlist on the iPod.  You can also skip songs forward and backwards 
from the iPod.  The iON interface does not disable any functionality of the iPod!  

 

RADIO DISPLAY DURING IPOD OPERTION

 

 

Some factory radio’s may show DISC and TRACK numbers on the display of the radio.  The 
iON interface does not send any information from the iPod to the radio.  This means that the 
DISC and TRACK numbers shown on the display will not and can not reflect the song number 
on the iPod due to the complex nature of the music library.  Some factory  radio’s may flash 
zeros on the display of the radio, or toggle back and forth between Tracks “1” and “2”.  All 
these are normal behaviors and do not represent a malfunction. 

 

CONTROLING THE IPOD FROM THE STEERING WHEEL CONTROLS

   

 

If your vehicle’s steering wheel controls have the ability to select track and control the forward 
and  rewind  functions  of  your  factory  CD  changer,  then  they  will  also  control  these  same 
functions on the iPod.   

 

Summary of Contents for Universal iON













Reviews: