Cleaning:
Unplug the power cord and let the projector cool down. Use a clean, slightly damp cloth to clean the
outside of the projector. Clean the lens with a lens cloth. Do not touch the lens with your fingers.
Replace lamp:
If the lamp does not work but the fuse still works, replace the
lamp. Unplug the projector and let it cool. Remove fluid wheel
(if it falls out during operations). Remove the upper, round
part (C) from the base (D). Do this by turning the projector the
other way around and then gently pulling the base apart. Do
not try to pinch the clips.
Now, while holding the round part (C), remove the 6 screws (E) around the edge of the projector.
Take the 2 halves of the round part (C) apart and remove the focus lens (A).
Remove the Bulb Connector (fitting) and the two screws from the Bulb Clamp (the clip that holds the
lamp in place). Replace the bulb and tighten the screws again, but be careful not to over tighten it.
Do not touch the lamp with bare hands, this will shorten the life of the lamp. Use a 20W 12V 10 Cold
Light 35 MM lamp. Only use lamps with these specifications. These are standard lamps that can be
found in every DIY store. Now place the two halves back together, carefully aligning the screw holes.
Turn back the focus lamp (A). Carefully click the base back. Do not mix the screws of the Bulb Clamp
and the screws of the 6 screw holes (E), the screws are shorter.
When you wish more information, please visit our website ww.nenko.com.
