6. Use
Hanging strap:
Should the hanging strap come loose during shipping, or when it is removed for cleaning, attach it to
the swing as follows: Wrap the webbing
strap around the top of the aluminum frame two times, looping one end of the webbing under the
other end both times. Then attach the
safety snap to the webbing. At this point the webbing should tighten around the frame under load.
To adjust the angle of the swing:
First, remove the client from the swing. Next, loosen the positioning plate knobs on the sides of the
swing until the teeth of the plates disengage. Rotate the angle of the seat to the desired position,
and tighten knobs until the teeth of the positioning plates fully engage. Do not loosen the knobs
more than is necessary to adjust swing.
After adjusting the swing to the proper position, you may add additional stability to the seat by tying
the cords to the outside loop of the frame.
7. Safety
Important:
NEVER ADJUST THE ANGLE OF THE SWING WHILE A CLIENT IS IN THE SWING. THIS COULD RESULT
IN SERIOUS INJURY.
• Never use the swing without the provided safety restraint system.
• Never leave clients unattended in the Variable Axis Swing.
•
Never use the swing without a Safety Rotational Device -- Failure to do so may result in
catastrophic failure of the swing
•
Before placing a client in the swing, hang the swing and make sure the hanging strap is in place and
secure. Failure to do this could result in
serious injury.
8. Care
•
Check for client allergies first.
•
Check with your infectious disease department before using these procedures.
•
Fabric machine washable cold water midl detergent
•
Air dry (do not tumble dry – cover will melt in dryer)
•
Clean frame with a damp cloth using soap and water or disinfectant.
Please visit our website www.nenko.com for more information.