Handwarmer Installation Guide
1)
Install power harness to the positive terminal on one battery and the negative
terminal on the other battery at the back of the two batteries with the harness
going to the power module. See Picture 1A below.
2)
Now you will want to install power switch module. This can be placed on top of
one of the batteries or on the plate holding the fans and power module. Be sure to
check for clearance for the seating before attaching Velcro. See Pictures 2A & B
below.
3)
Plug power harness into power switch module. This will be the plugs labeled IN
you will also want plug heater cable in using the two plugs labeled OUT. This
cable will go to the heater box.
4)
Next install hand warmer support plate using the longer bolts supplied in kit. First
remove the two 10-32 bolts holding the joystick to the joystick mount and then
place support plate under mount then install longer bolts through plate and mount
into joystick. See Picture 4A below.
5)
Install heater box as shown in photos. See Picture 5A below.
6)
Now you can plug cable into heater box and tie up cable so that it does not hang
down or out so as to not catch on anything.
7)
Your new heater has a remote power switch using some of the Velcro in the kit
attach in your desired place. See Picture 7A below.
