• Press the + or - button to set the frequency
RUN
• Rotate the dial to RUN
• Timer waters according to programmed time, duration, and frequency.
• The start times and cycle duration are maintained during OFF or RUN
mode.
• The dial must remain in RUN position for the cycle to run. If the dial is
turned to any other position, watering will stop.
• Rain drops will be shown when the watering is on, on the corresponding
valve.
SET RAIN DELAY (WATERING DELAY):
• With the dial in the RUN position, pressing (+) will cause a 24 hour delay to
the program.
• Same delay will occur on both Left and Right valves.
• Delays of 0, 24, 48 hours, and 72 hours are possible. Delay time can be
changed by p or - at any time.
• Display will flash between clock and hours remaining before programmed
cycle resumes.
• To remove watering delay, turn dial to OFF and then back to RUN or reduce
the delay time to 0.
MANUAL (INSTANT) WATERING:
• To water instantly without interrupting the set cycle, press the button
to
start watering.
• This mode will function only when the dial is on RUN position
• Choose Left or Right valve (Valves can have different watering duration
set)
• Press the + or - button to adjust from 0 to 240 minutes at any time.
• To resume programmed cycle, press the button again or rotate the knob to
OFF and back to RUN.
OFF
• Turning the dial to the OFF position from any other position will stop the
manual or programmed watering immediately.
RESET
• Pressing the reset button for 2 seconds will erase all the programs and the
Timer will return to factory shipped condition.
INSTALLATION
• Attach Timer to an outdoor hose faucet and turn faucet on after
programming.