2 |
P a g e
December 22, 2020
•
Remove the outer packaging CAREFULLY, (cardboard and bubble wrap or Styrofoam corners and
clear plastic). Inspect for concealed damage. Again, immediately file a claim with the freight carrier if
there is damage.
•
Remove the unit carefully from crate.
•
CAUTION –
This unit contains R290, a flammable hydro-carbon refrigerant. While installing,
moving, or using the freezer, do not disturb the refrigerant lines, (bend, puncture, or apply heat). If
you notice anything unusual, find damage, or it is not functioning properly, remove the unit from
service, and call an HVAC technician certified to handle flammable refrigerants.
•
The cabinet is intended for indoor use with a store temperature of 75 degrees (F) and 55% relative
humidity. Locate the cabinet to avoid direct sunlight, drafts from vents, air conditioning or open
doors that will affect the freezers performance.
•
The cabinet must be located 3 – 6 inches away from the back wall and the louvers (front and rear)
must be clear of any obstructions to ensure proper air flow to the condensing unit.
•
If installing paneling in front of freezer- Please take air flow under consideration. Trapped hot
discharge air will cause poor performance. It is important to have full opening on the paneling where
the louver exists.
o
NOTE
: Blocking the louvers on the customer or operator side of the cabinet will cause the
compressor to overheat and cause poor performance.
•
Before your new unit is connected to a power supply, check that the incoming voltage at the outlet is
the same as the data tag on the cabinet.
•
P
lug in the unit, turn the toggle switch “ON”.
Allow the freezer to run for at least 24 hours to ensure
that it reaches the temperature set point and ensure that the freezer has reached its operating
temperature before reloading the cabinet with product.
o
NOTE
: This is a pre-startup check to ensure the unit is working properly. Remember, our
factory warranty does not cover product loss!
•
Freezer is equipped with a digital temperature controller. The controller is preset for the proper
freezer temperature your operation requires.
•
If temperature adjustment is desired, the controller may be located behind the louver grill. Unplug
the unit before removing the louver. Increase or decrease the temperature in small increments and
allow the unit to stabilize. Repeat as needed to achieve desired temperature.
o
NOTE:
A Wiring Diagram is located inside the condensing unit area.
To set desired temperature, pay attention to decimal points. For example, to set controller at 5 degrees,
set to 5.0, NOT .5