1.This device is built in the over heat protection, it will shut itself off to prevent
damage from overheat, you can use it after the temperature back to normal .
2.Please try not
to use
it
over
2
minutes
one
time, although the
device
is
built
in
the
over heat
protection, however, life spam of the device may be reduced.
3.During use, please place the coil in the center of bolt/heating object, try not to
reach or close to large metal part where you don’t need to heat), otherwise it
will increase working load and slow heating speed of bolt. Please refer to Pic 4.
4.When the white coil insulation is breach, please replace with new insulation
pipe, or replace the coil, if you have to use it, please
not
use it in the way of Pic
1, Pic 2.
(
Breach of insulation pipe may lead to short circuit of induction coil, thus
may cause irretrievable damage to the heater)
5.Do not block the back end fan during working, otherwise cooling ability will
decrease, and cause overheat of the device very soon.
6.Please don't put this device in fridge, near the air conditioner vent, this may
cause condense water inside of the device and may damage the board.
7.Please don’t bend the power cord sharply, no matter in using or storage.
8.Please don’t open the device by yourself
.
Not a Good Way
Not a Good Way
Not a Good Way
Leave Gap between coil and heating object
Cause Short Circuit of Coil
Cause Short Circuit of Coil
Pic1
Pic2
Pic3
Pic4
USE RULES
Page 5
