4. Put the spray nozzle kit in the throttle body as shown and start the engine.
And then open the Ball Valve of fuel outlet port .
5. Keep the engine speed up to 1000 rpm and press the accelerator every 3~5
minutes to make the engine speed up to 2000 ~ 3000 rpm and keep this
state for 30 seconds. Then keep idle speed.
6. Do the flushing procedures as above until exhaust the detergent.
7. Reconnect the pipes and initialize the throttle.
Caution: It must initialize the Throttle Position Sensor by automotive scan tool
after cleaning. Otherwise the fault indicating lamp will lighten on, and PCM will
record a DTC.
