ELECTRICAL INFORMATION
Warning
Mains plug replacement
(UK & Ireland only)
If you need to replace the fitted plug of the tool, then follow the instructions below.
Machines that are connected direct to mains supply
For machines that are double insulated, do not require a connection to earth.
If in doubt consult a qualified electrician
The wires are coloured as follows
Blue
Neutral (N)
Brown
Live (L)
This machine comes with an earth wire this is as follows
Green/Yellow
Earth (E)
13amp BS 1363A Fuse
Always secure the wires in the plug terminals carefully make sure no loose strands are left exposed
as they can short circuit and cause injury, fire and or damaged the tool.
Secure the cable in the cord grip firmly.
Never use a light socket.
Never connect the live (L) or neutral (N) wires to the earth pin marked (E)
NOTE:
If your mains wires differ from the above consult a qualified electrician. Always make sure the
mains supply is of correct voltage and you use the correct fuse protection
Regularly inspect all machines electrical connection and wiring condition for damage. Any faults
detected should be immediately rectified before further use of the machine. Always have the wiring
checked by a qualified electrician.
In use ensure all wiring and extension cords are kept clear of any cutting tools, sharp objects and any
other workshop hazards such as wet floors, chemicals, solvents etc.
This machine is protected by a 13amp fuse make sure the correct fuse is used.
To prevent fire or shock hazards do not expose these products to rain or moisture.
