It can be used when assembling and disassembling the removal parts, structal part, which
need lifted, descended transported,it
’s the ideal tool for assembling and repairing in motor
repair shop, mobile garage.
Ⅱ
.Main construction
This jack is combined by
(1) Power unit (2) whole stand unit (3) saddle unit
Ⅲ
.Assembling before use
For transportation, the jack is separated into three components. When used first time
assembling according to the No.1 drawing
1. Wheel stand
①
Connect the two wheel stands
①
with the power unit
④
by inserting the in six-angled
bolt
②
(M12X70) and washer
③
into the proper hole on the power unit and tighten the
screw.
②
Assembling four castor wheels
⑤
together with spring washer
⑥
on the four
feet of the wheel stands
①
and tighten the nuts
②
.
2. Make the first part of piston into the hole
(φ28) of the saddle unit
⑧
at the proper
position and tighten the screw(M8)
⑨
3. Fasten the two cramps
⑩
with bolt(11)(M12x25)and washer
③
to the nut(12)(M12)on
the saddle unit
⑧
and close the screw, the distance between the two cramps can be
adjusted if needed.
4. Change the air vent valve(13) with a hole in the centre instead of the one without a
hole.
That
’s all for assembling
Ⅳ
.Instruction
1. Raising the saddle
Tighten the release valve handle (15) by turning in a clockwise direction and operate
the foot pedal(14) if by hand, place the handle in the foot operated handle sleeve,
operate the handle up and down.
2. Lowering the saddle
For safety, turn the release valve handle very slowly in counter-clockwise. Be sure not
exceed 25mm per second. If it lowers too fast, turn the release valve handle in
clockwise.
Ⅴ
.Warning
①
Be sure not exceed the rated capacity 0.6T
②
Be sure to load firmly on centre of the transmission jack. If not, adjust the handle to close
it.
③
After putting the load on it, use safety chain.
④
When lifting load, need work under it, must use the safety stand.
⑤
There must be enough oil in the cylinder so that the cylinder can operate regularly.
⑥
When remove the transmission jack, the saddle must be at the lowest position.
⑦
Keep the removal parts oiled, to avoid rusted.
