Hammer mode:
Drill in masonry, concrete and natural stone.
Drilling mode:
Drilling in wood, synthetic materials and
metal.
WARNING!
No function mode:
The motor turns without load,the shaft will
not turn. Do not set the switch like this.
It may damage the motor greatly.
Important! When hammer drilling
you will require a low pressure.
Too much pressure will place
unnecessary load on the motor.
Check the drill bits regularly. Re-
sharpen or replace blunt drill bits.
Do not use the chuck with SDS
connector in combination with the
hammer/hammer drill function!
Variable speed dial
Your tool is equipped with a variable speed
dial. The speed and impact force can be
adjusted by rotating the dial. Higher speeds
and impact force work best for faster
penetration when drilling or chiseling in hard
masonry material. Slower speeds work best
to reduce breakout when bits exit material
being drilled or chiseling material such as
plaster or tile (Fig. 4).
Regardless of the pressure applied on the
trigger, the tool will not operate any faster
than maximum speed setting selected.
Fig 4
This rotary hammer drill does not have
reverse direction, so always take care not
to force the drill in case the drill bit gets
stuck. Always make sure you keep the
drill going in and out to remove debris to
make sure the drill does not get stuck.
This drill does not have torque facility. It
is not recommended to use screwdriver
bits in this drill as it could damage the
screwdriver head or bit and could cause
serious injury
REMOVING ACCESSORIES
Accessories may be hot after use. Avoid
contact with skin and use proper protective
gloves or cloth to remove.
To remove an accessory, pull and hold
locking
sleeve backward and pull bit forward. All
accessories should be wiped clean after
removing.
NOTE:
The high efficiency available from the
rotary hammers can only be obtained if sharp
and undamaged accessories are used. The
"cost" to maintain sharp and undamaged
accessories is more than offset by the "time
saved" in operating the tool with sharp
accessories.
WARNING
!
WARNING
!
ASSEMBLY & OPERATION
11