Neilsen CT0346, Original Instructions Manual

Page: 4 / 12

INTRODUCTION
This chain block is for lifting not pulling.
SPECIFICATION
Stock No...........................CT0346.......................... CT0347
Load .................................1000kgs..................... ...2000kgs
Lift height ........................... 2.5M .............. ............... 3M
Hand force
(when fully loaded N) ........... 304.................. ...... ......314
Weight ............................... ..9kgs............................. 13kgs
HANDLING & STORAGE
Take care when handling and lifting. Do not drop the chain block.
Store in a dry location out of the reach of children.
HEALTH & SAFETY INFORMATION
GENERAL SAFETY INSTRUCTIONS
WARNING: - Before the use of this or any other lifting equipment all persons who
install, operate or maintain this equipment should read and fully understand this
manual. If chain blocks or any other lifting equipment presents the possibility of
personal injury or damage to property, then it should not be used.
- Ensure that the chain block is fully inspected before every use.
- Chain blocks are only to be operated by a trained operator.
- Do not exceed the maximum lifting capability of the chain block.
- Ensure that the fixing point is substantial enough to take the load which is intended
to be lifted.
- Ensure the chain block can swivel freely on this upper hook.
- Never allow the chain block housing to bear any support when lifting a load.
- Ensure the suspension hooks fits and sits freely within the support clamp.
- Ensure the chains are not twisted or obstructed to prevent free running of the chain.
- Never use undue effort to force the chain hoist to operate.
- Never allow oil or grease to come in contact with the brake.
- Never use the load chain as a sling.
- Never wrap the chain around the load which is to be lifted.
- Never leave the load suspended in the air unattended.
- Do not lower the hook to a point where the chain becomes taut between the lift
wheel and the loose end pin.
-
THE CHAIN BLOCK:
- Ensure the chain block is positioned directly over the load which is to be lifted, this
will prevent side lifting.
- While the load is lifted ensure no persons are under the load.