en
Operating the appliance
30
Childproof lock
You can secure the washer dryer to
prevent the set functions from being
changed inadvertently. To do this,
activate the childproof lock when the
programme has started.
Activating/deactivating: Touch and hold
the buttons
0
rpm
and
ñ
Finished in
for approx. 3 seconds. The symbol
E
is
indicated in the display. If the button
signal is activated, an acoustic signal
sounds.
■
E
lights up: The childproof lock is
activated.
■
E
flashes: The childproof lock is
active and the programme selector
has been adjusted. To prevent the
E
symbol from flashing, reset the
programme selector to the initial
programme. The symbol lights up
again.
Note:
The childproof lock may remain
activated until the next programme
starts, even after the washer dryer has
been switched off. If this is the case,
deactivate the childproof lock before the
programme starts and, if required, re-
activate after the programme starts.
Reloading the laundry
When the programme has started, the
laundry can be reloaded or taken out as
required.
Touch the
Start/Reload
A
button. The
washer dryer checks whether reloading
is possible.
Notes
■
If there is a high water level, high
temperature or if the drum is
rotating, the door remains locked
for safety reasons and reloading is
not possible.
If the following is indicated on the
display panel:
Õ
is lit
~
Reloading is not
possible. To continue the
programme, select the
Start/Reload
A
button.
■
Do not open the door until the door
lock symbol
Õ
goes out.
■
Do not leave door open for
a prolonged period – water could
run out of the laundry.
■
The reloading function cannot be
activated during the drying phase.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Select
Start/Reload
A
.
2.
Select another programme. If
required, adjust the default settings
and/or select additional functions.
3.
Select
Start/Reload
A
. The new
programme starts from
the beginning.
Interrupting or ending the
programme
For washing programmes at high
temperature:
1.
Touch the
A
button.
2.
To cool down laundry: Select
Rinse
.
3.
Touch the
A
button.
For washing programmes at low
temperature:
1.
Touch the
A
button.
2.
Select
Spin/Drain
.
3.
Touch the
A
button.
